All about product
Reinforced self-impression locksmith key for opening locks such as MOTTURA PROJECT VIPER/SECUREMME K3/MASTER-LOCK/Buonelle (Italy).
It is recommended to use sheet foil with a thickness of 0.06 mm.
Text in the video: This is the Italian Securemme K3. Italian Mottura Project VIPER. Masterlock - can be found in different doors, can be found in Chinese doors. Buonelle. All keys are similar. There is a power key for them, but it often breaks the cylinder and the lock is unusable after opening. That's why we made an impression tool with foil, and after it, the lock usually always remains intact. This is a very strong and powerful impression, so the included handle is long to make it easier to work, since it will require effort. We use foil 06. I have already prepared foil blanks. But I'll do one again now to show you, because it's important. If you make the form poorly, it will work poorly. We cut off the strip and move the strip to the right before shaping it. Thus. Now we swipe a plastic card in the center, and now along the remaining two edges. Then you can level it with your fingers. I align each guide very well. Now you can transfer it to the working side. By the way, lubricant is not required when opening these locks, but is advisable. It will be easier and faster with it, there is less chance that something will break there, so I will use a lubricant. We have 8 locks here, and now we’ll try to open all eight. We did not make a separate instrument for Mottura, since there are many wave options, so we decided to make a universal one. Slowly at first, then you can load it more and more, but don’t do it right away. That is, we are rocking. It spins with little effort. Now we can check the key. The lock is absolutely working. Another Mottura Project. Let's check the key. The lock remained operational. Another Mottura Project. Let's check the key. Works. This is Buonelle. Make sure the foil goes in without being wrinkled, otherwise it may not open. Masterlock. It fits into Masterlock more tightly, it’s better to even it out a little. And check when entering so that the foil does not tear. Let's try the key. The lock is working. Now Securemme K3. Securemme K3 comes with different profiles. There is a profile like ours, but there is also another. By the way, there is also a YALE cylinder, series 2000. And most likely this tool can open it too. We just don't have this lock in stock to check. Securemme also comes in tighter than Mottura. Let's check the key. The lock is working. Another Securemme K3. Let's check the key. The lock is working. Another K3. Lubricant is highly recommended. Let's check the key. The lock is working. So, here are 8 cylinders, we have opened all of them, all locks remain intact.
