All about product
Text from video: Hello, Lockmasters! Today we have a Spanish lock for review. Six-pin. The tool was made in the shortest possible time. Without anodizing, without anything. But it works. It can open and close to the left and to the right, so it works in both directions. Only to the right you will need to ease it and play with the tension force. We put the tool in the lock. I will try to show you as well as possible. It works. Now we have a task, we open to the left. We work by dividing. I have not disassembled the lock, but the pins here are interesting. Protection. But there are still nuances. The tension force is small. So, this is the first version of the lock. I will remove this vice. And at the moment it is blocked. I have two locks, I have not figured it out much. But in this case, the sixth, fifth and third positions are locking pins. These are when opening. The tension force is small. We press on the sixth, fifth position. Lightly. We scroll. It's blocked again. We repeat the same operation. And to the third position. The tool can be pulled out. Now I'll show you how to the right side. It will take a little longer. There, you see, it takes longer. The tension force is small. We work by clicks. I can't tell what kind of shaped pins are here. The highest height is here. This is the fourth position. It goes a little hard. So we weaken the tension force. And we go on to work on other positions. This is the only such drawback. Because it is very high. If you look closely at the key. The milling is even pressed through. We always weaken when we lower the handle of the manipulator. To some position. So that we can easily lower the pin. We need a position. This is the drawback in this direction. Therefore, it will take a little longer to open. It pops out, but that's okay. You need to correct it. Here I am showing you that it is also possible in this direction. But again, it is blocked there. We remember that it is the third position. Fifth. Sixth. On the blocker. We do it lightly, the tension force is small. Because the pins pop out. That's why it's a toy. But if we say that this tool was made in literally 5 days, as the special services demanded of us, then it didn't take long. These blockers will also complicate things. As they say, the emergency opening itself. In any case, it turns out that we overpress. And it gets blocked. We must not forget about the shooting. This is important. You see, even with three pins, you can mess around. Someone might think. Maybe throwing it over will help. I don't think it will work. Here we get two locks. There is protection against opening. Now we'll check. Is it possible to pull out the tool? The tool cannot be pulled out. We'll have to modify everything completely, and the opening itself. And we can unblock it. And another version of the lock. This is a lock with blockers. Note that it has such armor protection. And this lock, which has no protection. We install it. It's much easier here. It has no lock. We install it. The tension force is small. If nothing happens, we shot it off. Maybe the pins were pressed somewhere. And here, no problem. Thank you for your attention!
